1 special design holder

1 waterproof pencil

1 long Velcro strap (330 mm long)

15 self seal pouches (100 mm x 80 mm)

3 perforated A4 sheets (Insert size 90 mm x 60 mm, 9 per page)

Full instructions

Print any repetitive information (if required) onto the insert using either a PC or a pen

Seal insert inside a pouch

Place pouch into holder

Attach strap to arm or boat, using the Velcro strap (join two straps together and it goes round your thigh!)

Write the information that changes, e.g. race course, on the pouch with the pencil either on or off the water

When required, wipe off the pencil marks with a dry cloth and start again!

Always wash all components in fresh water following use

Always remove all pencil marks from the laminates before storage

Remove the pencil and Velcro strap from the holder and allow to dry naturally after use

Store components out of direct sunlight

Store sheets of inserts flat and away from moisture

Before printing onto the inserts, print onto a blank piece of A4 paper to check alignment

The holder will accept more than one laminate.  Why not put a laminate with a blank insert behind the one you are using, just in case

Place a dry cloth in a sealable bag for wiping your MARINECARD on the water

Both sides of the laminate can be used, however pencil marks may remain on the duller side when wiped with a dry cloth

The marks can be removed by wiping with methylated spirits